T3-3-2431CBH – Transmission Yokes – 1350 Series – 32 X 1.378 Splines – 1.888″ Hub Dia

• The "roller bearing tail housing" designation is critical -- this yoke is specifically machined for TH400 transmissions fitted with an aftermarket or upgraded roller bearing output rather than the OE bushing. The hub OD (1.888") and counterbore (0.625") are sized for the roller bearing carrier interface, not the standard bushing bore
• Installing this yoke in a standard bushing tail housing risks either a loose fit (causing seal leakage) or an interference fit (preventing installation)
• 32-spline only -- confirm the TH400 output shaft spline count before ordering; earlier TH400 builds used different counts
• Same 5.500" length as other short TH400 yokes -- appropriate for short-wheelbase drag race or high-performance street builds

The roller bearing tail housing conversion on the TH400 is a common upgrade in drag race applications where the output shaft side-load from high-torque launches destroys standard bushings quickly. This yoke must be ordered specifically for that conversion.