3152-1003 – CV Joint Kit – 28″ Splines dia – Bolt Hole Dia 8.7″ – 25 Spline

The 3152-1003 CV joint kit is a complete Rzeppa constant velocity joint assembly — inner race, outer race, ball bearings, cage, and all required hardware. It replaces the full CV joint as a unit, not just one component. The 3152-1003 CV joint kit is dimensioned for one specific application: outer diameter, spline count, and race widths are all matched and verified.

3152-1003 Cv Joint Kit — Rzeppa Specs & Fitment

The 3152-1003 CV joint kit specs: 100MM OD | 28 x 25 spline | 42 inner race | 40 outer race. Grand Cherokee, Liberty front differential, plunging style CV. Outer diameter determines fit in the housing bore. Spline count determines shaft engagement. Inner and outer race widths determine how the assembly stacks in the housing — all four specs must match. Substituting races from different part numbers causes uneven load distribution and early failure.

Pack the 3152-1003 CV joint kit thoroughly with CV grease during installation — fill the inner race cavity before seating the cage. CV joint failures from grease starvation happen faster than mechanical wear. Don't use wheel bearing grease — use CV-specific grease rated for the operating angle of your application.

Key Features

• Style: Rzeppa — constant velocity design, smooth power transfer at operating angle
• Outer dia: 100MM — must fit housing bore exactly
• Spline: 28 x 25 — shaft engagement spec
• Inner race width: 42
• Outer race width: 40
• Complete kit — all components matched and measured for correct assembly
• Note: Grand Cherokee, Liberty front differential, plunging style CV

Specifications

• SKU: 3152-1003
• Brand: UDS
• Style: Rzeppa
• Outer Dia: 100MM
• Spline Dia: 28
• Spline Count: 25
• Inner Race Width: 42
• Outer Race Width: 40
• Notes: Grand Cherokee, Liberty front differential, plunging style CV