3526-201 – Weld Yokes – 1350 Series – Butt Dia 1.766″ – Tube Dia Wall 2.000X0.120

The 3526-201 weld yoke is the weld-on tube-end connection for 1350 series driveshaft assemblies. It slides over or butts up to the driveshaft tube and welds in place, forming the permanent u-joint cradle at that end of the shaft. Butt diameter must match your tube OD precisely — a loose fit produces an off-center weld joint that no amount of balancing will fix.

3526-201 Weld Yoke — Tube Fit & Steel Specs

The 1350 series covers 3/4-ton trucks — F-250, Ram 2500, Dana 44/60 axles, performance 4x4. The 3526-201 weld yoke specs: fits 2.000X0.120" tube | 1.766" butt dia | 2.125" center-to-weld. EXTRA THICK EARS. Steel construction — DOM-compatible, full-penetration weld ready, standard for high-torque driveshaft applications. Center-to-weld dimension is critical for total shaft length calculations — it's the distance consumed by this yoke on that end of the tube.

Measure your tube OD before cutting and welding the 3526-201 weld yoke. Tack it in place first, check runout is within 0.005" before committing to full weld. A slight off-angle tack that gets welded solid will show up as vibration at 50+ mph that no balancer can fully correct.

Key Features

• Series: 1350 — 3/4-ton trucks — F-250, Ram 2500, Dana 44/60 axles, performance 4x4
• Tube fit: 2.000X0.120" — butt diameter is machined specifically for this OD
• Butt dia: 1.766" — must match tube OD precisely for a centered weld joint
• Center-to-weld: 2.125" — factors into total shaft length calculation
• Steel — DOM-compatible, full-penetration weld, standard drivetrain spec
• Brand: UDS
• Note: EXTRA THICK EARS

Specifications

• SKU: 3526-201
• Brand: UDS
• Series: 1350
• Material: Steel
• Tube Fit: 2.000X0.120"
• Butt Dia: 1.766"
• Center to Weld: 2.125"
• Notes: EXTRA THICK EARS