110679 Weld Yoke 1310 Series, Fits 2.500 x 0.095 Tube – Centerline to Weld 1.688

110679 UDS 1310 Weld Tube Yoke

The 110679 is a 1310 series steel weld tube yoke manufactured by UDS. In a driveshaft assembly, this yoke is welded to a cut driveshaft tube — the weld end seats against or inside the tube, and the yoke ears accept a 1310 series U-joint that connects to the mating yoke at the transmission, transfer case, or differential.

The tube specification is 2.500X0.095 — the yoke bore is machined for a 2.500-inch OD tube with 0.095-inch wall. Substituting a tube with the correct OD but a different wall thickness will produce an incorrect fit at the weld joint. The butt diameter of 2.321 inches is the outer dimension of the yoke at the weld face and determines how the yoke nests inside or butts against the tube end during assembly. The center-U-joint-to-weld dimension is 1.688 inches, measured from the U-joint centerline to the weld face; this value is used when calculating the finished overall driveshaft length after welding. Note: Butt Diameter 58.95 mm.

Specifications

• Part Number: 110679
• Brand: UDS
• Series: 1310
• Butt dia: 2.321
• Center u j to weld: 1.688
• Material: STEEL
• Tube dia wall: 2.500X0.095
• Notes: Butt Diameter 58.95 mm

Fitment & Installation Notes

Before welding the 110679, confirm the tube is 2.500X0.095 — both OD and wall thickness must match the yoke specification. The 1310 series ranks above 1210 in torque capacity, with a 1.062-inch cap diameter, suited for light-duty trucks, half-ton pickups, and most rear-wheel-drive passenger cars. A 1310 U-joint is required in the yoke ears; do not install a different-series joint. Clean and deburr the tube end before fitting the yoke to ensure a concentric weld bead — off-center welds create vibration and driveshaft imbalance.

Browse related Weld Yokes including 1310 and adjacent series configurations available with various tube OD and wall specifications.