2654-681 – Stub & Midship Shaft – 19 X 0.850 Splines – Butt Dia 2.375″ – Tube Dia Wall 2.500X0.065

The 2654-681 midshaft stub is the center section of a two-piece driveshaft — it carries the center support bearing and bridges the front and rear shaft assemblies. Spline count, spline diameter, and butt diameter are all spec-specific. The 2654-681 midshaft stub won't fit a different tube OD or a different output shaft spline, and substituting a close-but-not-exact part will produce vibration that traces directly back to this component.

2654-681 Midshaft Stub — Spline & Tube Dimensions

The 2654-681 midshaft stub specs: 19 X 0.850 spline | 775" spline length | 2.375" butt dia | 6.500" end-to-weld | fits 2.500 tube. 2252-683 or 2252-681 cvj weld yoke.. The butt diameter determines how the stub seats in the driveshaft tube — too loose and the weld joint runs off-center. Spline length determines engagement depth on the output shaft; short engagement under high torque loads damages the shaft splines before the stub shows any sign of wear.

When replacing a midshaft stub, measure both the tube ID and the output shaft spline count before ordering. Check runout on the new 2654-681 midshaft stub before welding — a stub with more than 0.005" runout will never balance correctly regardless of how many weights you add.

Key Features

• Spline: 19 X 0.850 — verify against output shaft
• Spline length: 775" — full engagement required under load
• Butt dia: 2.375" — must seat concentrically in driveshaft tube
• End-to-weld: 6.500" — factors into total shaft length
• Tube fit: 2.500 — designed for this tube specification
• Brand: UDS
• Note: 2252-683 or 2252-681 cvj weld yoke.

Specifications

• SKU: 2654-681
• Brand: UDS
• Spline: 19 X 0.850
• Spline Length: 775"
• Butt Dia: 2.375"
• End to Weld: 6.500"
• Tube Fit: 2.500
• Notes: 2252-683 or 2252-681 cvj weld yoke.