80992 M12-1.75 – Kit of 4 bolts for Ford applications , super Duty and other Ford

When rebuilding or servicing a Series driveline shaft, every component matters. The 80992U from UDS supplies the correct drivetrain component geometry for the specified application, maintaining the dimensional chain that keeps the assembly balanced and the U-joints properly retained. See notes: Ram 25000/3500 serrated flange bolts.

Part Specifications -- 80992U

Series Fitment

The 80992U is designed for direct use in Series driveshaft assemblies. Cross-reference the part number against the vehicle or equipment service manual to confirm correct application before installation. Factory cross-reference note: Ram 25000/3500 serrated flange bolts.

• Verify series designation matches both ends of the driveshaft assembly
• Inspect mating components for wear before installing new drivetrain component
• Replace in matched sets where applicable to maintain balanced service life

Assembly Guidance

Install the 80992U per the manufacturer service manual procedure. Ensure mating surfaces are clean and free of corrosion or burrs before assembly. Use the correct installation tooling to avoid damaging precision-ground surfaces. Torque all fasteners to specification.

• Do not reuse snap rings or retaining clips -- always install new hardware
• Inspect bearing bores and cross ears for wear before assembly
• Confirm correct phasing on multi-joint shafts after any yoke or end component replacement

Availability & Support

Universal Driveshafts stocks 80992U and hundreds of related Series driveshaft components for same-day order processing. Our technical team is available to assist with part identification, series verification, and complete driveshaft assembly solutions.