2926-31 – Weld Yokes – 7290 Series – Butt Dia 2.875″ – Tube Dia Wall 3.000X0.065

Building or rebuilding a 7290 series driveshaft means getting the weld yoke right first. The 2926-31 weld yoke is machined for one tube diameter and one series — those two specs are non-negotiable. Get the butt diameter wrong and the weld joint is already compromised before you strike the arc.

2926-31 Weld Yoke — Tube Fit & Steel Specs

The 2926-31 weld yoke specs: fits 3.000X0.065 tube | 2.875" butt dia | 1.812" center-to-weld. Steel construction — DOM-compatible, full-penetration weld ready, standard for high-torque driveshaft applications. Center-to-weld dimension is critical for total shaft length calculations — it's the distance consumed by this yoke on that end of the tube.

Measure your tube OD before cutting and welding the 2926-31 weld yoke. Tack it in place first, check runout is within 0.005" before committing to full weld. A slight off-angle tack that gets welded solid will show up as vibration at 50+ mph that no balancer can fully correct.

Key Features

• Series: 7290 — application-specific
• Tube fit: 3.000X0.065 — butt diameter is machined specifically for this OD
• Butt dia: 2.875" — must match tube OD precisely for a centered weld joint
• Center-to-weld: 1.812" — factors into total shaft length calculation
• Steel — DOM-compatible, full-penetration weld, standard drivetrain spec
• Brand: UDS

Specifications

• SKU: 2926-31
• Brand: UDS
• Series: 7290
• Material: Steel
• Tube Fit: 3.000X0.065
• Butt Dia: 2.875"
• Center to Weld: 1.812"