9980-49 – Center Support Bearing – Subaru Application – 1.181″ ID – 1.750″ Center Bearing To Base

The 9980-49 center support bearing supports the midshaft section of a two-piece driveshaft, keeping it running concentric with the vehicle's drivetrain axis. When this bearing fails, the midshaft droops and the driveshaft angles change — you'll feel it as a vibration that gets progressively worse at highway speed. The 9980-49 center support bearing is the correct replacement for Subaru series applications, with the exact inner diameter and mount hole spacing your application requires.

9980-49 Center Support Bearing — Subaru Series Dimensions & Mount Specs

The 9980-49 center support bearing specs: 1.181" inner dia | 1.750" center-to-base | 6.750" mount spacing. CB mounts at an offset . one bracket sits below 1.75" and the opposite side mounts .75". Application: Subaru series. Inner diameter must match the midshaft stub OD exactly — a loose fit allows the bearing to walk on the shaft, which causes vibration and accelerates wear on both the bearing race and the shaft surface. Mount hole center-to-center spacing must match your crossmember bracket.

When replacing a center support bearing on a two-piece shaft, replace the complete assembly — bearing race, rubber isolator, and bracket together. A new race in an old hardened rubber mount still vibrates. The rubber isolator is what actually absorbs the midshaft movement; without it the bearing transmits every frequency directly to the frame.

Key Features

• Application: Subaru series — verify your driveshaft series matches
• Bearing inner dia: 1.181" — must match midshaft stub OD exactly
• Center-to-base: 1.750" — height from shaft centerline to mounting surface
• Mount hole spacing: 6.750" — must match crossmember bracket exactly
• Complete assembly — bearing race, rubber isolator, and bracket as one unit
• Rubber isolator included — absorbs midshaft vibration, reduces NVH to frame
• Note: CB mounts at an offset . one bracket sits below 1.75" and the opposite side mounts .75"

Specifications

• SKU: 9980-49
• Brand: UDS
• Application: Subaru Series
• Bearing ID: 1.181"
• Center to Base: 1.750"
• Mount Hole Spacing: 6.750"
• Notes: CB mounts at an offset . one bracket sits below 1.75" and the opposite side mounts .75"