3504-10 – End Yoke – 1350 Series – 1.188″ Splines Dia – 1.875″ Hub Dia”,

Not all end yokes are created equal -- the material and machining process determine whether a yoke lasts 200,000 miles or fails in 20,000. The 3504-10 is a UDS 1350 Series end yoke manufactured from high-grade steel with machined spline bores, precision bearing seats, and controlled snap ring grooves. It is the correct choice for any drivetrain that demands durability over the long haul.

Material and Construction

The raw material for this yoke is selected for its combination of tensile strength and machinability. After rough forming, the spline bore, hub, and bearing seats are finish-machined on CNC equipment to hold tolerances that exceed OEM specifications. The BS snap ring groove is cut to a consistent depth and width, ensuring that the snap ring seats fully and cannot back out under vibration.

• High-grade steel construction -- resists deformation under high-torque loads
• CNC-machined bearing bores -- consistent, round seats for U-joint caps
• Controlled spline form -- 1.188" diameter, 10-spline interface
• Protective coating -- resists corrosion during storage and service life

Dimensional Reference

Every dimension on this yoke has a functional purpose. The 1.875" hub diameter determines how the yoke registers against the output shaft seal or retainer. The 3.125" center-to-end measurement affects driveshaft operating length. The 1.656" through hole prevents interference with internal shafts or speedometer cables. None of these dimensions can be ignored when selecting a replacement.

Application and Installation

This yoke is designed for CHRYSLER 8.75. Installation requires a clean output shaft free of nicks, corrosion, or damaged splines. Inspect the snap ring groove in the shaft before installing the new yoke. Torque the retaining hardware to specification -- do not rely on thread friction alone to retain the yoke under high-RPM operation.

Pair with a fresh 1350 Series U-joint for a complete driveline service. Reusing an old U-joint with a new yoke negates the benefits of the replacement.

Part 3504-10 is a UDS product. Universal Driveshafts stocks a complete range of 1350 Series end yokes, U-joints, and driveshaft components. Contact our technical team for fitment assistance.