9533-4724 Unwelded 1310 series

Precision drivetrain repair begins with correctly-dimensioned replacement hardware. The 9553-SF drivetrain component from UDS is engineered to Series 1310 specifications, ensuring proper fit and function in any compatible shaft assembly.

Part Specifications -- 9553-SF

Dimensional Fit

The 9553-SF is designed for direct use in Series 1310 assemblies. Cross-reference the part number against the vehicle or equipment service manual to confirm correct application before installation. Contact Universal Driveshafts technical support to verify fitment if the original part number is unknown.

• Verify series designation matches both ends of the driveshaft assembly
• Inspect mating components for wear before installing new drivetrain component
• Replace in matched sets where applicable to maintain balanced service life

Service & Replacement Notes

Install the 9553-SF per the manufacturer service manual procedure. Ensure mating surfaces are clean and free of corrosion or burrs before assembly. Use the correct installation tooling to avoid damaging precision-ground surfaces. Torque all fasteners to specification.

• Do not reuse snap rings or retaining clips -- always install new hardware
• Inspect bearing bores and cross ears for wear before assembly
• Confirm correct phasing on multi-joint shafts after any yoke or end component replacement

Availability & Support

Universal Driveshafts stocks 9553-SF and hundreds of related Series 1310 components for same-day order processing. Our technical team is available to assist with part identification, series verification, and complete driveshaft assembly solutions.