Conversion Driveshaft – Flange to U-Joint – Aluminum, 5″ OD, Ford F250/F350, 4WD, Super Duty Truck

When the factory driveshaft on a 2000 - 2018 Ford F250/F350 SD reaches the end of its service life, the 5A1480X1410-SLIP_Ford_FL-UJ provides a factory-spec replacement that installs without yoke modifications, carrier bearing changes, or CV adapter hardware. The 5" OD aluminum tube and Series 1410 end joints match every critical dimension of the OEM assembly.

Specifications -- 5A1480X1410-SLIP_Ford_FL-UJ

Vehicle Fitment Details

The 5A1480X1410-SLIP_Ford_FL-UJ is designed specifically for the 2000 - 2018 Ford F250/F350 SD with drivetrain. Before ordering, confirm that your vehicle's transmission output yoke and rear axle pinion yoke both specify Series 1410 U-joint geometry. This application covers the Custom body configuration.

• Confirm year, model, and cab/bed or wheelbase against the product listing
• Check both yoke series before ordering to avoid mismatch
• Inspect carrier bearing and crossmember condition if the vehicle had previous vibration issues

Engineering & Balance

Aluminum driveshafts like the 5A1480X1410-SLIP_Ford_FL-UJ offer measurable benefits over steel replacements in street and light-performance applications. Reduced rotating weight decreases drivetrain inertia, improving acceleration response and reducing stress on transmission output and axle pinion bearings. The 5" OD OD provides ample torsional stiffness for the 1410 joint series torque rating, while maintaining the clearances required by the factory undercarriage.

• Lower unsprung rotational mass vs. steel OEM shaft
• Precision dynamic balance reduces NVH (noise, vibration, harshness)
• Corrosion-resistant surface -- no annual undercoating required
• Direct bolt-in: no transmission crossmember or tunnel modification

Installation Overview

Installing the 5A1480X1410-SLIP_Ford_FL-UJ requires standard hand tools and a floor jack. Support the rear axle independently before removing the factory shaft. Match-mark the rear yoke before removal so the new shaft can be phased identically. Torque all flange bolts or U-bolt nuts to the vehicle manufacturer's specification and re-check after the first 50 miles.

Order with Confidence from Universal Driveshafts

Universal Driveshafts specializes in direct-fit replacement and performance driveshaft assemblies. The 5A1480X1410-SLIP_Ford_FL-UJ is built to order and ships with a full dynamic balance certification. Contact our technical staff for wheelbase-specific length verification or to discuss an upgraded joint series if you are running a modified powertrain.