Driveshaft – Dodge | Charger | 2WD | 3.6L | 2015-22 | Automatic

Replacing a worn or damaged driveshaft on a 2015 - 2022 Dodge Charger? The 4A1350_2894-323-DC delivers a direct-fit, performance-grade solution. Constructed from aluminum tubing at 4.0" OD OD, this shaft is balanced as an assembly, minimizing residual imbalance that causes floor vibration and premature U-joint wear. 8 Speed Auto configuration is pre-set to match the factory application.

Specifications -- 4A1350_2894-323-DC

Vehicle Fitment Details

The 4A1350_2894-323-DC is designed specifically for the 2015 - 2022 Dodge Charger with 8 Speed Auto drivetrain. Before ordering, confirm that your vehicle's transmission output yoke and rear axle pinion yoke both specify Series 1350 U-joint geometry. Overall collapsed length is 73.875" -- verify against the existing shaft with the vehicle at ride height.

• Confirm year, model, and cab/bed or wheelbase against the product listing
• Check both yoke series before ordering to avoid mismatch
• Inspect carrier bearing and crossmember condition if the vehicle had previous vibration issues

Engineering & Balance

Aluminum driveshafts like the 4A1350_2894-323-DC offer measurable benefits over steel replacements in street and light-performance applications. Reduced rotating weight decreases drivetrain inertia, improving acceleration response and reducing stress on transmission output and axle pinion bearings. The 4.0" OD OD provides ample torsional stiffness for the 1350 joint series torque rating, while maintaining the clearances required by the factory undercarriage.

• Lower unsprung rotational mass vs. steel OEM shaft
• Precision dynamic balance reduces NVH (noise, vibration, harshness)
• Corrosion-resistant surface -- no annual undercoating required
• Direct bolt-in: no transmission crossmember or tunnel modification

Installation Overview

Installing the 4A1350_2894-323-DC requires standard hand tools and a floor jack. Support the rear axle independently before removing the factory shaft. Match-mark the rear yoke before removal so the new shaft can be phased identically. Torque all flange bolts or U-bolt nuts to the vehicle manufacturer's specification and re-check after the first 50 miles.

Order with Confidence from Universal Driveshafts

Universal Driveshafts specializes in direct-fit replacement and performance driveshaft assemblies. The 4A1350_2894-323-DC is built to order and ships with a full dynamic balance certification. Contact our technical staff for wheelbase-specific length verification or to discuss an upgraded joint series if you are running a modified powertrain.