3103-12 1310 Series Transmission Yoke

Part No. 3103-12 (also written 3103/12) Transmission Yokes, 1310 Series, 10 x 1.375 Splines, 2.125" Hub Dia

$94.11

In stock1 ready to ship

Most stock parts ship the same day when ordered before 2pm EST; processing times may vary.

  • Free shipping on parts orders over $1,000
  • 14-day returns
  • Fitment help: (813) 524-6491

Specifications 3103-12 · 1310 Series Transmission Yoke

How to measurePoint at a letter to read its measurement
BADEC
Part number
3103-12
Part type
Transmission Yoke
Condition
New
Series
1310
Hub diameter
2.125
Splines count diameter
10 x 1.375
Center u-joint to end
4.875
Counter bore diameter
875
Weight
4.13 lb

Fitment

Used in boat applications, Fits onto standard jet drive

1310 series parts use 1.062" u-joint bearing caps on a 3.219" snap-ring-to-snap-ring width (nominal). Confirm the cap diameter on the mating yoke or joint before ordering.

Estimate shipping to your ZIP

Estimate shipping

Live UPS rates from our shop in Florida. Parts orders over $1,000 ship free — tubing and complete driveshafts always ship at the UPS rate.

Local pickup in Florida — free

About 3103-12

3103-12 -- 1310 Marine Jet Drive Transmission Yoke

The 3103-12 is designed for standard marine jet-drive installations where the engine output shaft uses a 10-spline, 1.375" pitch diameter interface. The oversized 2.125" hub diameter is a distinguishing feature of jet-drive yokes -- the larger diameter accommodates the heavy-wall housing bore of the jet pump input coupling. The 0.875" counterbore seats on the pump coupling pilot to maintain alignment, which is critical in a marine environment where vibration from water ingestion can otherwise accelerate coupling wear.

At 4.875" center-to-end, this transmission yoke is sized for standard jet pump geometry. The 10-spline count is much lower than automotive applications -- these splines carry torque rather than provide fine-pitch indexing, so they rely on a tight interference fit rather than close-clearance slip engagement. Apply anti-seize compound to the splines during installation to prevent corrosion bonding in the marine environment. The 1310-series U-joint at the output end (1.062" cap) should be replaced annually or every 100 hours in saltwater applications, whichever comes first.

Related Transmission Yokes in the 1310 series

See the full table

3103-12 questions

What series is 3103-12?

3103-12 is a 1310 series transmission yoke. Nominal 1310 dimensions are 1.062" bearing caps on a 3.219" snap-ring-to-snap-ring width. Measure the cap diameter on your old joint to confirm the series before ordering.

What spline count does 3103-12 have?

3103-12 is cut for 10 x 1.375 splines (count × major diameter). Count the splines on the output shaft and measure across the major diameter to confirm.

Is 3103-12 in stock?

Yes. 1 is in stock in Florida. Most stock orders placed before 2 pm EST on a weekday ship the same day.