3103-23S 1310 Series Transmission Yoke

Part No. 3103-23S (also written 3103/23S) MAZDA RX8 AUTO, machined shoulder off hub Transmission Yoke 1310

$78.46

In stock2 ready to ship

Most stock parts ship the same day when ordered before 2pm EST; processing times may vary.

  • Free shipping on parts orders over $1,000
  • 14-day returns
  • Fitment help: (813) 524-6491

Specifications 3103-23S · 1310 Series Transmission Yoke

How to measurePoint at a letter to read its measurement
BADC
Part number
3103-23S
Part type
Transmission Yoke
Condition
New
Series
1310
Counter bore diameter
0
Center u-joint to end
5.750
Hub diameter
1.575
Splines count diameter
23 X 1.201
Weight
1.06 lb

Fitment

MAZDA RX8 AUTO, machined shoulder off hub

1310 series parts use 1.062" u-joint bearing caps on a 3.219" snap-ring-to-snap-ring width (nominal). Confirm the cap diameter on the mating yoke or joint before ordering.

Estimate shipping to your ZIP

Estimate shipping

Live UPS rates from our shop in Florida. Parts orders over $1,000 ship free — tubing and complete driveshafts always ship at the UPS rate.

Local pickup in Florida — free

Alternative parts for 3103-23S

Same fitment, another number or brand. Check the notes before you substitute.

AddPicPart #Price Series Hub Dia Splines Count & Dia Center U-Joint to End Counter Bore Dia Notes
3103-23 3103-23
$84.46
1310 1.575 23 X 1.201 5.750 0 Toyota applications.

About 3103-23S

Part Number3103-23S Series1310 (1.062" U-joint cap diameter) Splines23 x 1.201" Hub Diameter1.575" Center U-Joint to End5.750" ModificationMachined shoulder removed from hub ApplicationMazda RX-8 automatic transmission

The Mazda RX-8 automatic uses a 23-tooth output shaft at 1.201" pitch diameter -- a specification used exclusively on Mazda platforms and not shared with Nissan, Toyota, or domestic applications. The "S" suffix indicates the shoulder has been machined off the hub, which is required because the RX-8 automatic tailshaft bore does not have clearance for the raised shoulder found on the base 3103-23 part. Installing the non-machined version will prevent the yoke from seating fully on the output shaft, leaving a gap at the seal housing and causing immediate oil leakage. Confirm your transmission is the automatic variant -- the RX-8 manual uses a different yoke specification. Pair with a 1310-series U-joint at the driveshaft forward end.

Related Transmission Yokes in the 1310 series

See the full table

3103-23S questions

What series is 3103-23S?

3103-23S is a 1310 series transmission yoke. Nominal 1310 dimensions are 1.062" bearing caps on a 3.219" snap-ring-to-snap-ring width. Measure the cap diameter on your old joint to confirm the series before ordering.

What spline count does 3103-23S have?

3103-23S is cut for 23 X 1.201 splines (count × major diameter). Count the splines on the output shaft and measure across the major diameter to confirm.

Is 3103-23S in stock?

Yes. 2 are in stock in Florida. Most stock orders placed before 2 pm EST on a weekday ship the same day.