7-0081NG is your go-to CV ball kit for 1310 and 1330 series applications. This non-grease configuration is designed to deliver reliable performance in CV joint assemblies. With a ball diameter of 1.125 inches and a stud bore diameter of 0.5 inches, this kit provides the right fit for your driveline needs.
Before installation, ensure you have the right tools and verify that the components are clean and free of debris. A common mistake is not checking the seal dimensions; the outer diameter of 1.34 inches and a seal height of 0.16 inches are critical for proper sealing. Make sure to pack the joint with the specified grease amount if applicable, and always use a new boot and clamps to prevent contamination.
- Check the compatibility with 1310 and 1330 series.
- Verify the ball diameter of 1.125 inches for a proper fit.
- Ensure the stud bore diameter is 0.5 inches before installation.
- Inspect the seal dimensions: 1.34 inches OD and 0.16 inches height.
- Always replace the boot and clamps during installation.
By following these guidelines, you can avoid common pitfalls and ensure a successful installation of the 7-0081NG CV ball kit. This part is essential for maintaining the integrity of your driveline system.
