UDS – 5-3022x Universal Joint Combo U joint 1310 x 3RL Convert from 1310 series to 3R/S44

The 5-3022x is a 3R X 1310 series -- 3R series -- specialty cross pattern combination (OSR + ISR) snap ring retention universal joint measuring 1.125"/1.063" dual cap | 2.556"/3.219" dual width. This is a combination u-joint -- it bridges two different series in one cross. The 5-3022x is greaseable with zerk fitting. Every 5-3022x is verified for cap diameter, bearing width, and snap ring groove dimensions before it ships from Universal Driveshafts.

5-3022X -- 3R X 1310 Series Cap & Width Specifications

The it specs: 1.125"/1.063" dual cap | 2.556"/3.219" dual width. Cap diameter determines which yoke bore it fits -- the cap must seat fully into the yoke without play. Dual cap diameters (1.125" and 1.063") bridge two different series yokes in a single cross. Bearing width (2.556" and 3.219" across the body) controls the span between yoke ears. A cross that is too wide won't fit; too narrow and the snap rings don't seat in the groove. SAGINAW COMCO 1310 X3R.

Confirm both ends of the driveshaft before installing the this unit. Combination u-joints require matching the correct series at each end -- the 1.125" caps go into one yoke, the 1.063" caps go into the other. Getting the orientation wrong means the driveshaft won't balance and the the assembly will fail early. Measure both yoke bores with calipers before ordering -- don't rely on the vehicle spec alone.

Installation Notes for this u-joint

Before installing the it, clean the yoke bores of any rust, burrs, or old bearing material. The bearing cups must drop in by hand -- never drive them in with a hammer directly on the cup. Use a proper cross-and-bearing installation tool or a press. Driving a cup in at an angle cocks the needle bearings and destroys the the part before it ever sees load.

After installation, verify full rotation without binding. A binding cross indicates a cup is cocked or seated too deep. The this component should articulate freely through the full operating angle of your driveshaft before the vehicle is lowered off the lift.

Key Features

• Series: 3R X 1310 series -- 3R series -- specialty cross pattern
• Cap dia: 1.125" x 1.063" -- must match yoke bore exactly
• Width: 2.556" x 3.219" -- controls yoke ear span
• Style: combination (OSR + ISR) snap ring retention -- verify yoke groove type before ordering
• Greaseable -- zerk fitting included, service at regular intervals
• This is a combination u-joint -- it bridges two different series in one cross.
• Part number: 5-3022-1XU
• Brand: UDS
• Note: SAGINAW COMCO 1310 X3R

Specifications

• SKU: this u-joint
• Part Number: 5-3022-1XU
• Brand: UDS
• Series: 3R X 1310
• Cap Dia 1: 1.125"
• Cap Dia 2: 1.063"
• Width 1: 2.556"
• Width 2: 3.219"
• Snap Ring Style: COMBO
• Lube: Yes -- grease fitting
• Notes: SAGINAW COMCO 1310 X3R