2-40-1221 – Stub & Midship Shaft – 16 X 1.375 Splines – Butt Dia 2.875″ – Tube Dia 3.000

The 2-40-1221 midshaft stub is the center section of a two-piece driveshaft — it carries the center support bearing and bridges the front and rear shaft assemblies. Spline count, spline diameter, and butt diameter are all spec-specific. The 2-40-1221 midshaft stub won't fit a different tube OD or a different output shaft spline, and substituting a close-but-not-exact part will produce vibration that traces directly back to this component.

2-40-1221 Midshaft Stub — Spline & Tube Dimensions

The 2-40-1221 midshaft stub specs: 16 X 1.375 spline | 2.250" spline length | 2.875" butt dia | 6.438" end-to-weld | fits 3.000 tube. The butt diameter determines how the stub seats in the driveshaft tube — too loose and the weld joint runs off-center. Spline length determines engagement depth on the output shaft; short engagement under high torque loads damages the shaft splines before the stub shows any sign of wear.

When replacing a midshaft stub, measure both the tube ID and the output shaft spline count before ordering. Check runout on the new 2-40-1221 midshaft stub before welding — a stub with more than 0.005" runout will never balance correctly regardless of how many weights you add.

Key Features

• Spline: 16 X 1.375 — verify against output shaft
• Spline length: 2.250" — full engagement required under load
• Butt dia: 2.875" — must seat concentrically in driveshaft tube
• End-to-weld: 6.438" — factors into total shaft length
• Tube fit: 3.000 — designed for this tube specification
• Brand: UDS

Specifications

• SKU: 2-40-1221
• Brand: UDS
• Spline: 16 X 1.375
• Spline Length: 2.250"
• Butt Dia: 2.875"
• End to Weld: 6.438"
• Tube Fit: 3.000