When working on the Mitsubishi Endeavor, the 1680-14 Center Support Bearing is a critical component to ensure proper driveline function. This bearing supports the two-piece driveshaft at its midpoint, maintaining alignment and reducing whip during operation. With a bearing ID of 1.181″ and a center-to-center mounting hole spacing of 7.402″, it’s essential to verify these dimensions before installation.
One common mistake during installation is pre-loading the rubber isolator. This can lead to premature failure and increased vibration. Ensure that the mounting bracket is aligned correctly before tightening the fasteners. Also, check the condition of the rubber isolator; a hardened or collapsed isolator can cause significant driveline vibration and noise, especially at highway speeds.
- Confirm the bearing ID of 1.181″ for compatibility.
- Ensure the center-to-center mounting hole spacing is 7.402″.
- Do not pre-load the rubber isolator during installation.
- Align the mounting bracket before tightening.
- Inspect for any signs of rubber deterioration or bearing noise.
By following these guidelines, you can maximize the service life of the 1680-14 Center Support Bearing under load conditions. This part is specifically designed for the rear center bearing on the three-piece driveshaft of the Mitsubishi Endeavor, making it a reliable choice for your repair or performance build.
