1340-20 Stub Shaft
Slip

Part No. 1340-20 (also written 1340/20) Stub Midship Shaft, 20 X 1.310 Splines, Butt Dia 2.435", End To Weld 7.500

$59.82

In stock1 ready to ship

Most stock parts ship the same day when ordered before 2pm EST; processing times may vary.

  • Free shipping on parts orders over $1,000
  • 14-day returns
  • Fitment help: (813) 524-6491

Specifications 1340-20 · Stub Shaft

How to measurePoint at a letter to read its measurement
EBADFC
Part number
1340-20
Part type
Stub Shaft
Condition
New
Style
Slip
Tube wall
0.065"
Butt diameter
2.435
End to weld
7.500
Splines count diameter
20 X 1.310
Splines length
1.765
Tube diameter
2.560
Weight
4.62 lb

Fitment

TOYOTA

Estimate shipping to your ZIP

Estimate shipping

Live UPS rates from our shop in Florida. Parts orders over $1,000 ship free — tubing and complete driveshafts always ship at the UPS rate.

Local pickup in Florida — free

About 1340-20

A failed midship shaft announces itself as vibration that worsens at highway speed and does not disappear after U-joint replacement. The 1340-20 stub midship shaft -- 20 X 1.310 splines, 2.435" butt, 2.560" x 0.065" tube -- provides a precision replacement that restores the dimensional accuracy required for a vibration-free two-piece driveshaft.

Midship Shaft Failure Modes

Stub midship shafts fail for several reasons: center support bearing collapse allows tube deflection; corrosion attacks the tube wall, reducing structural stiffness; and impact damage introduces runout that unbalances the entire driveshaft assembly. The 1340-20 eliminates these issues with a fresh, balanced tube and factory-accurate dimensions.

Part Data

SpecificationValue
SKU1340-20
Splines20 X 1.310"
Spline Length1.765"
Butt Diameter2.435"
Tube O.D.2.560"
Tube Wall Thickness0.065"
End to Weld7.500"

Center Support Bearing Interface

The center support bearing seats on the butt diameter (2.435") of the 1340-20. The bearing must be fully pressed to its seat and the bracket fasteners torqued correctly to hold the midship shaft in the proper driveline angle. An incorrectly shimmed or loose center support bearing transfers vibration into the cab and will damage the bearing itself in short order.

Replacement Steps

  • Remove the rear driveshaft section first to gain access to the midship shaft
  • Unbolt the center support bearing bracket from the crossmember
  • Mark the front yoke orientation before sliding off the output shaft
  • Press center support bearing onto 1340-20 butt diameter
  • Install in reverse order; shim center bearing for correct driveline angle
  • Road test to verify absence of vibration at all speeds

Get the Right Part Fast

Universal Driveshafts stocks the 1340-20 and matching center support bearings. Order both together for a complete midship assembly. Our driveline team can help you verify fitment using your vehicle's driveshaft data plate dimensions.

Related Stub & Midship Shaft

See the full table

1340-20 questions

What spline count does 1340-20 have?

1340-20 is cut for 20 X 1.310 splines (count × major diameter). Count the splines on the output shaft and measure across the major diameter to confirm.

Is 1340-20 in stock?

Yes. 1 is in stock in Florida. Most stock orders placed before 2 pm EST on a weekday ship the same day.