One Piece Driveshaft Measuring Guide

How to measure a one piece driveshaft for cars, vans, 2WD trucks and 4WD front and rear shafts, for each transmission output type.

Use This Guide To Measure Driveshaft Length For Most: Cars, Vans, 2wd Trucks, And Some 4wd Front And Rear Shafts.

One piece driveshaft from a seal or rubber boot extension to an end yoke or flange

Measurement Instructions: It is essential to measure the driveshaft length while the vehicle’s axle is in its normal riding position. Ensure the axle is properly supported on safety stands and not suspended.

This procedure is critical for obtaining accurate measurements.

TRANSMISSION OUTPUT TYPE - SEAL

Measurement (A) – DRIVESHAFT LENGTH:
Measure from end of rubber seal on the transmission to the flat face of the end yoke or flange on the differential.

Measurement (B) – SPLINE EXTRUSION LENGTH:
Measure from end of rubber seal to end the of the transmission output. If spline is recessed in rubber seal, measurement can be noted as ø

TRANSMISSION OUTPUT TYPE -RUBBER BOOT EXTENSION

Measurement (A) – DRIVESHAFT LENGTH:
Measure from end of rubber boot extension on the transmission to the flat face of the end yoke or flange on the differential.

Measurement (B) – SPLINE EXTRUSION LENGTH:
Measure from end of rubber boot extension on the end of transmission output. If spline is recessed in rubber boot extension, enter ø.

Use This Guide To Measure Driveshaft Length For Most: 4wd Front Shafts And Some 4wd Rear Shafts

One piece driveshaft from an end yoke or flange to an end yoke or flange

Measurement Instructions: It is essential to measure the driveshaft length while the vehicle’s axle is in its normal riding position. Ensure the axle is properly supported on safety stands and not suspended.

This procedure is critical for obtaining accurate measurements.

TRANSMISSION OUTPUT TYPE - END YOKE

Measurement (A) – DRIVESHAFT LENGTH:
Measure from center of u-joint/flats on the end yoke on the transmission output to the face of the end yoke or the face of the flange on the differential input end.

TRANSMISSION OUTPUT TYPE - FLANGE

Measurement (A) – DRIVESHAFT LENGTH:
Measure from the flat of the flange on the transmission output to the center of the u-joint on the end yoke or the face of the flange on the differential input end.

Shop End Yokes

Not sure which part you have?

Send us the measurements or a photo and we will find the part number.

Contact us (813) 524-6491