N° de pièce 3-28-57-1 Fourchette à souder sur tube 1350 Ser', pour: 2.750 x 0.083, Diam. d'emmanchement: 2.594 Inch Axe à soudure: 2 Inch SOLID BUTT

3-28-57-1: 1350 Series Weld Tube Yoke -- Drivetrain Component Guide

The drivetrain has no redundant load paths -- every torque-carrying component must perform correctly or the system fails. The 3-28-57-1 is the weld tube yoke position in that load chain for 1350 series applications, providing tube OD 2.750 x wall 0.083, butt dia 2.594 with forged construction and production-controlled tolerances.

Specification Data

Failure Modes and Prevention

A worn weld tube yoke typically presents as vibration at certain speed ranges, a clunk on throttle engagement, or visible play when you grab the driveshaft near the yoke and rock it. Left unaddressed, it accelerates u-joint wear, can score the output shaft seal contact area, and in severe cases causes shaft separation. Replacing the 3-28-57-1 as part of a scheduled drivetrain refresh -- rather than waiting for failure -- is the lower-cost strategy in the long run.

Fitment Checklist

• Tube od 2.750 x wall 0.083, butt dia 2.594 -- verified against this part before ordering
• Series 1350 u-joint cross in service or on order for this shaft end
• Mating component (output shaft / companion flange) in serviceable condition
• Retaining hardware (snap rings, strap bolts, or flange bolts as applicable) renewed if previously heat-cycled
• Shaft balance acceptable after installation -- road test confirms this

Note: SOLID BUTT - CAN BE TURN DOWN TO 2.000 X 0.125

Order the 3-28-57-1 from Universal Driveshafts today. In-stock items ship fast from our warehouse.