N° de pièce DSS-1810EYC53.750 renforcé série 1810 Arbre de transmission Center Croison de cardan To Center Roulement = 53.750" - Open Croison de cardan to Midship Fourchette d'extrémité, Certified Arbre de transmission OEM SPICER

DSS-1810EYC53.750 OEM Spicer 1810 Series Midship Driveshaft — 53.750" CL-to-Center Bearing

The DSS-1810EYC53.750 is an OEM Spicer 1810 series certified driveshaft section in open U-joint to midship end yoke configuration, with a center U-joint to center bearing dimension of 53.750 inches. This is the front section of a two-piece driveshaft assembly: the open U-joint connects at the transmission or transfer case output, and the midship end yoke terminates at the frame-mounted center support bearing. The 1810 series U-joint cap diameter is 1.875 inches — this governs the bore size in every mating yoke throughout the assembly.

At 53.750 inches, DSS-1810EYC53.750 is one of the longest midship sections in the 1810 certified driveshaft line. This length targets long-wheelbase vocational and commercial truck applications where geometry requires an extended front driveshaft section. The 0.750-inch increment in the part number is not arbitrary — 53.750 inches is a distinct dimension that corresponds to specific OEM frame bracket positions. Substituting a 53-inch or 54-inch section will misalign the center support bearing, causing angular contact stress in the bearing and characteristic vibration that increases proportionally with shaft speed. OEM Spicer Certified construction ensures factory dynamic balance at full length, and the tube specification maintains adequate critical speed margin for commercial operating RPMs.

Specifications

• Part Number: DSS-1810EYC53.750
• Brand: OEM Spicer
• Series: 1810
• CL to Center Bearing: 53.750"
• U-Joint Cap Diameter (1810 series): 1.875"
• Configuration: Open U-joint to Midship End Yoke
• Assembly Type: Certified Driveshaft

Fitment & Installation Notes

Before ordering DSS-1810EYC53.750, measure the distance from the front U-joint centerline to the frame bracket centerline with the vehicle at ride height. The fractional dimension (53.750 inches) must match within measurement tolerance — use a tape measure with 1/16-inch or finer resolution and measure twice. Confirm all mating components are 1810 series (1.875" U-joint cap bores), the center support bearing inner diameter matches the midship stub shaft OD, and the rear driveshaft section length and series are correct.

At this length, critical speed evaluation is important. For standard commercial truck applications running factory gearing and tire sizes, the OEM Spicer tube specification provides adequate margin. However, if the vehicle has been modified with taller gearing or the operating speed envelope has changed from the original design intent, verify the driveshaft critical speed rating for this length and tube specification before operating at maximum vehicle speed.

Install DSS-1810EYC53.750 with yoke ears in phase at both U-joint ends. Torque center bearing bracket hardware to specification with bearing housing seated flat against the bracket. Recheck driveshaft operating angles at ride height and at full suspension droop to confirm U-joint angles remain within 1810 series operating limits. This is especially relevant in chassis applications that have been lifted or lowered from factory geometry.

Explore related Certified Driveshaft assemblies including 1810 series rear sections and center support bearing hardware.