Free U.S. shipping on parts over $1,000

Driveshaft designer

Build the drawing step by step: the style, the front end, the middle on a two-piece shaft, the rear end, then your measurements. Each measurement is lettered A, B, C… and says exactly where it starts and ends. Print the sheet or send it to our shop. Free, no account needed.

  1. 1Style Two piece
  2. 2Front end CV joint with splined stub
  3. 3Middle U-joint coupling
  4. 4Rear end U-joint, bearing caps
  5. 5Measurements Type them in

Type each measurement in inches in the table; Enter moves to the next one. Click a letter on the drawing to jump to its row. The measurements stay in this page's link, so you can print or share it.

Driveshaft drawing UDS-2P-CVSTUB-UJOINT-CAPS Two piece · NTS · inches
FRONT · transmissionREAR · axleABCDEFGHI

Measurements

RefDescriptionInches
AOverall length: End of the splined stub to U-joint center
BEnd of the splined stub to the center of the support bearing
CCenter of the support bearing to U-joint center
DEnd of the splined stub to center of the middle U-joint
ECenter of the middle U-joint to U-joint center
FFront tube length, weld to weld
GRear tube length, weld to weld
HFront tube outside diameter
IRear tube outside diameter

How to measure

  • Measure with the shaft installed and the vehicle at ride height, or with the slip collapsed to its running length.
  • A U-joint center is the center of the cross. A flange or mounting face is the face that bolts to the vehicle.
  • Weld to weld is the bare tube between the two weld beads.
  • The drawing is not to scale.

Job

Universal Driveshafts Universal Driveshafts LLC · Florida, USA · (813) 524-6491 · inquiry@universaldriveshafts.com
Drawing no.UDS-2P-CVSTUB-UJOINT-CAPS
StyleTwo piece
Date2026-11-18
ScaleNTS
UnitsInches
Sheet1 of 1
Send it to the shop New drawing Price a build in the online builder

The drawing, your measurements and the job lines travel with the message. The job lines stay in this browser; they are not part of the link.