Driveshaft designer

Draw the shaft you need, dimension it and print the sheet, or send it to our shop with your measurements attached. Free to use, no account needed.

Click any {dimension} on the drawing or a row in the table, type the measurement in inches and press Enter or Tab to move to the next one. Your values are saved in this page's link, so you can print, share or send it to the shop.

Driveshaft drawing 06+61RQ+20R Two piece · NTS · inches

Measurements

RefDescriptionInches

Legend

A
Overall length, front end to rear end
B
Front end to center bearing (B1), center bearing to rear end (B2)
C
Front shaft, end to joint center (C1); rear shaft, joint center to end (C2)
W
Tube length, weld to weld
T
Tube outside diameter

Measure with the shaft installed and the vehicle at ride height, or compressed to the running length. Joint centers are the cross centerlines; flange ends are measured at the flange face.

Job

Customer
Vehicle or application
Phone
Notes
Universal Driveshafts Universal Driveshafts LLC · Florida, USA · (813) 524-6491 · inquiry@universaldriveshafts.com
Drawing no.06+61RQ+20R
StyleTwo piece
Date2026-11-16
ScaleNTS
UnitsInches
Sheet1 of 1
Price this build in the online builder Send it to the shop

The drawing and your measurements travel with the message. Sections and dimensions are drawn not to scale, from the supplier's library, with permission.