• 813- 644- 5707
  • Info@universaldriveshafts.com
Send Us A Picture of what you need
Make An Appointment

Two Piece Driveshaft Measuring Guide Flange to End Yoke

INFORMATION

Two Piece Driveshaft Measuring Guide

Flange to End Yoke

 IMPORTANT: Vehicle must be on a level surface with suspension at normal ride height for proper measurements. When measuring to the center bearing, measure to the center of the round or slotted carrier bearing bolt holes.  Many carrier mounts are slotted for adjustment.

DRIVESHAFT LENGTH

Measurement (A) - Front Driveshaft Length:
Measure from end of rubber seal on the transmission to the center of the carrier bearing bolt holes.

Measurement (B) - Rear Driveshaft Length:
Measure from the center of carrier bearing bolt holes to the end yoke flats (center of ujoint) on the differential.

SPLINE EXTRUSION LENGTH

Measurement (C) - Spline Extrusion Length:
Measure from rubber seal to end the of the transmission output/spline. If spline is recessed in rubber seal, enter ø.
Contact Us

    Name:*

    Email:*

    Phone Number:

    Message:



    * Required Fields

    INFORMATION

    Two Piece Driveshaft Measuring Guide

    Flange to End Yoke

     IMPORTANT: Vehicle must be on a level surface with suspension at normal ride height for proper measurements. When measuring to the center bearing, measure to the center of the round or slotted carrier bearing bolt holes.  Many carrier mounts are slotted for adjustment.

    DRIVESHAFT LENGTH

    Measurement (A) :
    Measure from the transmission output flange face to the center of the carrier bearing bolt holes.

    Measurement (B) :
    Measure from the center of carrier bearing bolt holes to the flats (center of u-joint or flats) on the end yoke at the differential.
    Skip to content